Installation of Torch Arm, Torch Carrier Assembly and Torch
Install Torch Arm (Fig. 3, Item A) by attaching it to the two threaded studs in the face of the
MSA Machine Ring Gear at the 12 o'clock Position. Secure with the Wing Nuts on the studs.
Install and secure Torch Carrier (Fig. 3, Item B) with hole for Torch outward on Torch Arm.
Install Torch in Torch Clamp (Fig. 3, Item 2) and one (1) adjust to stand off distance
recommended by the Torch manufacturer.

The Torch Clamp Base (Fig. 3 Item 1) is marked 0, 60, and 90. Use "0" Position for square cuts
(no bevel). Positions 60 and 90 make the appropriate bevel to produce a "V" Groove of 60 and
90 degrees respectively when the two pipe ends are butted together.
Note: Before starting to cut or bevel, rotate Torch one full turn
around the pipe to be sure Torch Tip will clear all the way.

Picture refers (A) - Torch Arm 03.0101.001